Functioning
The pulse caused by pressing the button on the remote controller sends the encoded signal to the receiver. The remote control has a protection against breaking the transmission after releasing the button. Thanks to this, even the shortest activation of the function causes transmission of a full data frame. Data transmission from the remote control is signaled by a flashing red LED on the remote control. When the signal is recognized, the receiver will change the contact position to the opposite.
RS-407B receiver cooperates with dedicated F&F production devices: RS-P (pilot) and RS-N (under plaster box Ø60 transmitter) transmitters. Up to 32 remote controls can be stored in the receiver’s memory.
The range of the system is up to 100m (the range depends on many factors, including: atmospheric conditions (humidity), terrain characteristics (reflection), receiver and transmitter stack height, and all types of obstacles, such as walls).
ATTENTION!
Before the final assembly of the receiver, perform tests.
The receiver is equipped with a PROG button that allows you to link a particular remote control / button to the receiver and to delete the receiver’s memory.
Programming
Pressing and holding the PROG> 5s button enters the programming state. After entering the learning mode, the receiver waits for incoming transmissions from the remote control (pressing the selected remote control button). The program is verified. If the button of a particular remote control has not been pre-programmed, identification data will be saved. You can assign multiple pilots during one open receiver programming session. A short press of the <1s button causes the exit from the programming state. Pressing and holding the PROG> 8s button erases the memory. After the erase operation from the non-volatile memory, all the pilots data are deleted, and then the memory is formatted for reprogramming.
